ARDUINO UNO R3 Starter KIT (46 elements)

Practical starter kit with UNO R3 CH340 - set of 46 elements. The perfect kit for just starting out - for a beginner to learn programming in ARDUINO.
Kit contains everything you need to learn the basics of electronics and programming.
Description of Basic Arduino UNO - Starter KIT
Arduino programming learning kit with UNO R3 board
Power is taken via USB cable from the computer or through a container of R6 batteries
The circuit is mounted on a contact board without the need for soldering
We can make our first circuits using LEDs.

List of elements:
UNO R3 CH340 board (maple) - 1 piece
Red LEDs - 5 pcs
Yellow LEDs - 5 pcs
Green LEDs - 5 pcs
Resistors 4 types of 10 pieces each:
220Ohm
1KOhm
10KOhm
100KOhm
Jumpers in different colors - 20 pcs.
TACT buttons with colored caps - 6 pcs.
Photoresistors - 2 pcs.
DC power cable from a 9V battery

Description of UNO R3 main board clone:
Supply voltage: 7 V to 12 V
Fully compatible with Arduino Uno Rev3
Microcontroller: ATmega328 - operating voltage 5V
Maximum clock frequency: 16 MHz
SRAM: 2 kB
Flash memory: 32 kB (5kB reserved for bootloader)
EEPROM memory: 1 kB
iN-OUT inputs 14 including as many as 6 PWM
current capacity of a single pin 40mA
Number of analog inputs: 6 (A/D converter channels)
Serial interfaces: UART, SPI, I2C
External interrupts
Connector: USB socket
Soldered ISP connector
Plate dimensions: 75 x 54 x 15 mm
pin spacing 2.54mm (can be mounted in contact boards)
uSB cable included

Module fully compatible with Arduino Uno R3. (This means that it can be programmed through the Arduino IDE environment using available libraries.)
The module has:
aTmega328 microcontroller - the chip is clocked with a 16MHz clock signal
14 digital inputs/outputs,
6 PWM channels - e.g. for controlling servos / motors e.g SG-90
6 analog inputs
popular communication interfaces
uSB connector on CH340
dC power socket
rESET button
pins used to connect the AVR programmer.